It really is a single-shot pistol because it only shoots one round, and then the action must be manually cycled again, after the trigger is released, in order for it to fire another round. If at any point, I hold the trigger down, as would be the case under normal firing conditions, the striking assembly never engages to the rear it always follows the bolt closed. I let go of the trigger, cycle the action, Striking assembly engages and stops, bolt goes forward, pull the trigger, NOTHING.Īfter this point, the striking assembly never comes forward until I remove the lower from the upper. In stock 4.99 Add to cart Note: this item is only compatible with the Mini UZI and the UZI Pistol Export Notice: This is an item controlled for export by the International Traffic in Arms Regulations (ITAR). I let go of the trigger, cycle the action, firing pin engages and stops, bolt goes forward,pull the trigger, the Striking assembly clicks. This UZI Firing Pin Spring Guide Rod is for the UZI Pistol and the Mini UZI. I:Ĭycle the bolt, firing pin engages and stops, bolt goes forward, pull the trigger, Striking assembly clicks. I have an issue where every time I put the gun together. In an uzi, the hammer/firing pin is all one piece called the "striking assembly". There is no traditional hammer that strikes a firing pin. Remember, an Uzi is different than a normal fire arm. I bailed my receiver out of 10-day jail at PRK yesterday, and I am in the process of building up the gun. I am in the process of building up an Uzi.
0 Comments
Leave a Reply. |